FRONT DRIVE SHAFT ASSEMBLY(for 1ZR-FAE, 2ZR-FAE) INSTALLATION

PROCEDURE

1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING LH

   
   

   1. Install a new hole snap ring.

2. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING RH

   Tech Tips

   Use the same procedures described for the LH side.

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

   
   

   1. Coat the spline of the inboard joint shaft with oil.

      Tech Tips

      Be sure to use the same type of oil that is used for the transaxle.

   2. 

      Align the shaft splines and tap in the drive shaft with a brass bar and hammer.

      Note

      
      

      • Make sure that the snap ring opening is facing downwards when installing the drive shaft.

      • Be careful not to damage the oil seal, boot or dust cover.

4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

   Tech Tips

   Use the same procedures described for the LH side.

5. INSTALL FRONT AXLE ASSEMBLY LH

   Click here

6. INSTALL FRONT AXLE ASSEMBLY RH

   Tech Tips

   Use the same procedures described for the LH side.