REVOLUTION SENSOR REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • w/ Navigation System (for HDD):

      After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE BATTERY

    Click here

  4. REMOVE BATTERY CARRIER

    Click here

  5. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  6. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  7. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  8. REMOVE TRANSMISSION REVOLUTION SENSOR (NT)

    A00543X

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  9. REMOVE TRANSMISSION REVOLUTION SENSOR (NIN)

    A0053EL

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.

  10. REMOVE TRANSMISSION REVOLUTION SENSOR (NOUT)

    A0058NS

    1. Disconnect the transmission revolution sensor connector.

    2. Remove the bolt and transmission revolution sensor.

    3. Remove the O-ring from the transmission revolution sensor.