OIL COOLER INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION OIL COOLER ASSEMBLY

    A0057V4

    1. Coat 2 new O-rings with CVT fluid FE and install them to the transmission oil cooler.

    2. Install the oil cooler to the continuously variable transaxle with the 3 bolts.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }
    3. A0053WHE03
      Text in Illustration
      *1 Red Paint Mark
      *2 Green Paint Mark

      Connect the 2 water by-pass hoses to the transmission oil cooler.

      Note

      Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

  2. INSTALL BATTERY CARRIER

    Click here

  3. INSTALL BATTERY


    1. Install the battery tray.

    2. Install the battery.

    3. Install the battery clamp with the bolt and tighten the nut.

      Torque:
      for bolt
      17 N*m  { 168 kgf*cm, 12 ft.*lbf }
      for nut
      3.5 N*m  { 36 kgf*cm, 31 in.*lbf }

    4. Connect the cable to the positive (+) battery terminal.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. ADD ENGINE COOLANT

    Click here

  6. ADD CONTINUOUSLY VARIABLE TRANSAXLE FLUID


    1. Add continuously variable transaxle fluid Click here.

  7. INSPECT FOR COOLANT LEAK

    Click here

  8. INSTALL REAR ENGINE UNDER COVER LH

    Click here

  9. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  10. INSTALL FRONT LOWER BUMPER ABSORBER

    Click here

  11. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here