SHIFT PADDLE SWITCH INSPECTION

PROCEDURE

1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	Component without wire harness connected (Transmission Shift Switch Assembly)
      *b	for LH
      *c	for RH

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LH Tester Connection Shift Position Specified Condition SFTD - ECC "-" shift paddle operated and held (down-shift) Below 2.5 Ω SFTD - ECC1 "-" shift paddle operated and held (down-shift) Below 2.5 Ω SFTD - ECC "-" shift paddle not operated (down-shift) 1 MΩ or higher SFTD - ECC1 "-" shift paddle not operated (down-shift) 1 MΩ or higher
      for RH Tester Connection Shift Position Specified Condition SFTU - ECC1 "+" shift paddle operated and held (up-shift) Below 2.5 Ω SFTU - ECC1 "+" shift paddle not operated (up-shift) 1 MΩ or higher

      If the result is not as specified, replace the transmission shift switch assembly.

2. INSPECT NO. 1 SWITCH WIRE

   
   

   1. Connect the No. 1 switch wire connector to the transmission shift switch assembly.

   2. Disconnect the steering pad switch connector from the No. 1 switch wire.

   3. 

      Text in Illustration

      *a	Component without wire harness connected (No. 1 Switch Wire)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition SFTD - ECC "-" shift paddle operated and held (down-shift) Below 2.5 Ω SFTU - ECC "+" shift paddle operated and held (up-shift) Below 2.5 Ω SFTD - ECC "-" shift paddle not operated (down-shift) 1 MΩ or higher SFTU - ECC "+" shift paddle not operated (up-shift) 1 MΩ or higher