SHIFT LEVER INSTALLATION

PROCEDURE


  1. INSTALL SHIFT LEVER ASSEMBLY

    Note

    Check that the park/neutral position switch and shift lever are in neutral.

    A0057K4E02
    Text in Illustration
    *A for LHD *B for RHD

    1. Install the shift lever assembly with the 4 bolts. Tighten the bolts in the order shown in the illustration.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Connect the 2 connectors and 4 clamps to the shift lever assembly.

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Turn the nut of the transmission control cable 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.

      A0056XJE02
      Text in Illustration
      *1 Stopper *2 Nut
      A0054CA Turn in this Direction A0056SR Push in this Direction

    2. Install the outer part of the transmission control cable to the shift lever assembly. Check that the spring is positioned at "A" and push in the stopper.

      A0053NRE02
      Text in Illustration
      *1 Stopper *2 Nut
      *3 Shift Lever Assembly *4 Spring
      A0054CA Install in this Direction - -

      Tech Tips

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    3. A0058LJE02
      Text in Illustration
      *1 Transmission Control Cable Lock Piece
      *a Side View
      *b Bottom View
      A0054CA Push in this Direction

      Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the transmission control cable lock piece toward each other and upward to pull out the transmission control cable lock piece.

    4. A0055MCE02
      Text in Illustration
      *1 Transmission Control Cable Lock Piece

      Connect the end of the cable to the shift lever assembly.

      Note


      • Make sure that the transmission control cable lock piece is pulled up.

      • Push on the end of the cable all the way to the base of the pin.

    5. A0058KKE02
      Text in Illustration
      *1 Transmission Control Cable Lock Piece
      *2 Adjuster Case
      A0054CA Push in this Direction

      Push the transmission control cable lock piece into the adjuster case.

      Note

      Securely push in the transmission control cable lock piece until it locks.

  3. INSPECT SHIFT LEVER POSITION

    Click here

  4. INSTALL CONSOLE BOX ASSEMBLY

    Click here