TRANSMISSION CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  5. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY


    1. Remove the air cleaner filter element sub-assembly from the air cleaner case sub-assembly.

  8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  9. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  10. REMOVE BATTERY

  11. REMOVE BATTERY TRAY

  12. DISCONNECT RADIATOR PIPE

    Click here

  13. REMOVE BATTERY CARRIER

    Click here

  14. REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here

  15. REMOVE REAR ENGINE UNDER COVER LH

    Click here

  16. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  17. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR

  18. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  19. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

    Click here

  20. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  21. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. A0054XY

      Disconnect the end of the transmission control cable from the shift lever.

      Text in Illustration
      A0054CA Disconnect in this Direction
    3. A00594YE02
      Text in Illustration
      *1 Stopper
      *2 Nut
      A0054CA Rotate in this Direction
      A0056SR Pull out in this Direction
      A0053B4 Disconnect in this Direction

      Pull out the stopper of the transmission control cable.

      Note

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

  22. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. A0058YV

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    2. Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

    3. A0053SL

      Remove the 2 bolts and disconnect the transmission control cable assembly from the transmission control cable support.

    4. A00545M

      Remove the bolt and disconnect the transmission control cable assembly from the rear engine mounting insulator.

    5. A005533

      Remove the 2 bolts and transmission control cable assembly.