LUMBAR SUPPORT ADJUSTER ASSEMBLY(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE VERTICAL SEAT ADJUSTER KNOB CAP

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE LH

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD LH

    Click here

  6. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK PAD


    1. A0056BZ

      w/ Seat Heater System:

      Disconnect the connector.

    2. A00591T

      Remove the separate type front seatback pad.

  9. REMOVE LUMBAR SUPPORT ADJUSTER ASSEMBLY LH


    1. A005464

      Disconnect the connector.

    2. A00545N

      Detach the 8 hooks and remove the seatback spring.

    3. A00535FE02
      Text in Illustration
      *1 Back Sheet

      Pull the wire harness and disconnect it from the 2 back sheets as shown in the illustration.

    4. A0057VBE02
      Text in Illustration
      *1 Back Sheet
      *2 Hook A
      *3 Hook B
      *4 Cable Tie

      Detach the 4 hooks A and fold back the 2 back sheets.

    5. Cut off the 2 cable ties, detach the 2 hooks B, and then remove the lumbar support adjuster assembly LH from the seatback spring.