FRONT POWER SEAT MOTOR ASSEMBLY(for Front Vertical) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE RECLINING POWER SEAT SWITCH KNOB

    Click here

  3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

    Click here

  4. REMOVE FRONT SEAT CUSHION SHIELD LH WITH FRONT SEAT NO. 1 INNER CUSHION SHIELD LH

    Click here

  5. REMOVE FRONT POWER SEAT SWITCH LH

    Click here

  6. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR (for Driver Side)

    Click here

  7. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

    Click here

  8. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

    Click here

  9. REMOVE FRONT SEAT INNER CUSHION SHIELD LH

    Click here

  10. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Click here

  11. REMOVE POWER SEAT MOTOR ASSEMBLY (for Front Vertical)


    1. B0040LC

      Remove the 3 screws and shield bracket.

    2. B0040F7

      Disconnect the connector.

    3. B0040MB

      Using a 6 mm socket hexagon wrench, remove the bolt.

    4. Put a 4 mm (0.157 in.) drill bit into a drill.

    5. B0040QGE02
      *a 5 mm

      Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill as shown in the illustration.

      Tech Tips

      Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

    6. B0040LU

      Lightly press the drill against each of the 4 rivets shown in the illustration, and drill off the flange of each rivet.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.

      • Be careful of the drilled rivet as it may become hot.

    7. B0040GU

      Lightly press the drill against each of the 2 rivets shown in the illustration, and drill off the flange of each rivet.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.

      • Be careful of the drilled rivet as it may become hot.

    8. Remove the power seat motor assembly with bracket.

    9. B0040L1

      Lightly press the drill against each of the 2 rivets shown in the illustration, and drill off the flange of each rivet.

      Note


      • Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.

      • Do not pry the rivet with the drill because this may cause damage to the installation holes of the rivet or the drill bit.

      • Be careful of the drilled rivet as it may become hot.

    10. Remove the power seat motor assembly.

    11. Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled area.