RELAY ON-VEHICLE INSPECTION

PROCEDURE


  1. INSPECT TSS C HTR RELAY (Pre-crash Safety City Heater Relay)

    A0056UA

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 - 5 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      3 - 5 Battery voltage is applied to terminals 1 and 2 Below 1 Ω
      1 - 5 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher
      2 - 3 Battery voltage is not applied to terminals 1 and 2 10 kΩ or higher

      If the result is not as specified, replace the TSS C HTR Relay (Pre-crash safety city heater relay).