SIDE AIRBAG SENSOR(for Front Door) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  6. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  7. REMOVE FRONT DOOR NO. 1 STIFFENER CUSHION

    Click here

  8. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  9. REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY


    1. A00547V

      Disconnect the connector.

    2. Remove the bolt and No. 2 side airbag sensor assembly.