CENTER AIRBAG SENSOR ASSEMBLY INSTALLATION

PROCEDURE


  1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A00539EE01
      Text in Illustration
      *a Waterproof Sheet

      Check that the waterproof sheet is properly set.

    4. Install the center airbag sensor with the 3 bolts.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

      Note


      • If the center airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connectors, replace it with a new one.

      • When installing the center airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

    5. Check that the center airbag sensor is not loose.

    6. Connect the connector.

    7. Return both sides of the floor carpet to their original positions and install the 2 clips.

      A0052EF

  2. INSTALL FRONT CONSOLE BOX

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.