AIRBAG SYSTEM Diagnosis Circuit

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.

DTCs are output by the blinking of the SRS warning light.

Tech Tips


  • When each warning light remains blinking, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in each ECU is suspected.

  • A DTC output mode signal is transmitted through the CAN communication system to each ECU including the center airbag sensor. Thus, when all systems do not enter DTC output mode, there may be an ECM malfunction.

WIRING DIAGRAM

A0053O9E01

CAUTION / NOTICE / HINT

Note


  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  • When disconnecting the cable from the negative (-) battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected Click here.

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if a CAN communication system DTC is output.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B

    REPAIR TROUBLE AREAS INDICATED BY OUTPUT DTCS Click here

    A

  2. CHECK HARNESS AND CONNECTOR (DLC3 - ECM)


    1. A0053Y9E02
      Text in Illustration
      *A except 1AZ-FE
      *B for 1AZ-FE
      *a Front view of DLC3
      *b

      Front view of wire harness connector

      (to ECM)

      Turn the ignition switch off.

    2. Disconnect the A40 connector from the ECM.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      except 1AZ-FE
      Tester Connection Condition Specified Condition
      D8-13 (TC) - A40-41 (TC) Always Below 1 Ω
      for 1AZ-FE
      Tester Connection Condition Specified Condition
      D8-13 (TC) - A40-27 (TC) Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    1. A0057ZGE02
      Text in Illustration
      *a Front view of DLC3

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D8-4 (CG) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (TC OF ECM - BODY GROUND)


    1. A0058G8E02
      Text in Illustration
      *A except 1AZ-FE
      *B for 1AZ-FE
      *a

      Front view of wire harness connector

      (to ECM)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      except 1AZ-FE
      Tester Connection Condition Specified Condition
      A40-41 (TC) - Body ground Always 1 MΩ or higher
      for 1AZ-FE
      Tester Connection Condition Specified Condition
      A40-27 (TC) - Body ground Always 1 MΩ or higher

    OK

    REPLACE CENTER AIRBAG SENSOR ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR