OIL AND OIL FILTER REPLACEMENT

CAUTION / NOTICE / HINT

CAUTION:


  • Prolonged and repeated contact with engine oil will cause removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.

  • Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use a waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners or solvents.

  • For environmental protection, used oil and used oil filters must be disposed of at designated disposal sites.

PROCEDURE


  1. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the 3 clips and open the oil pan drain service cover.

    3. Remove the oil pan drain plug and gasket, and drain the engine oil into a container.

  2. REMOVE OIL FILTER SUB-ASSEMBLY



      1. A005589E02

        Using SST, remove the oil filter sub-assembly.

        SST
        09228-06502

  3. INSTALL OIL FILTER SUB-ASSEMBLY



      1. Check and clean the oil filter sub-assembly installation surface.

      2. Apply clean engine oil to the gasket of a new oil filter sub-assembly.

      3. Lightly screw the oil filter sub-assembly into place by hand. Tighten it until the gasket contacts the seat.

      4. A0054NGE01

        Using SST, tighten the oil filter sub-assembly.

        SST
        09228-06502

        Depending on the work space available, choose from the following:


        • If enough space is available, use a torque wrench to tighten the oil filter sub-assembly.

        Torque:
        18 N*m  { 178 kgf*cm, 13 ft.*lbf }

        • If not enough space is available to use a torque wrench, tighten the oil filter sub-assembly 3/4 of a turn by hand or use a common wrench.

  4. ADD ENGINE OIL


    1. Clean and install the oil pan drain plug together with a new gasket.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

    2. Add new engine oil.

      Standard Oil Grade
      Oil Grade Oil Viscosity (SAE)
      API grade SL, SM or SN multigrade engine oil

      • 15W-40
      API grade SL "Energy-Conserving", SM "Energy-Conserving", SN "Resource-Conserving" or ILSAC multigrade engine oil

      • 0W-20

      • 5W-20

      • 5W-30

      • 10W-30
      Standard Capacity
      Item Specified Condition
      Drain and refill without oil filter change 3.9 liters (4.1 US qts, 3.4 Imp. qts)
      Drain and refill with oil filter change 4.2 liters (4.4 US qts, 3.7 Imp. qts)
      Dry fill 4.7 liters (5.0 US qts, 4.1 Imp. qts)

    3. Install the oil filler cap.

  5. INSPECT FOR OIL LEAK


    1. Start the engine. Make sure that there are no oil leaks from the areas that were worked on.

  6. INSPECT ENGINE OIL LEVEL

    Click here