EXHAUST MANIFOLD REMOVAL

PROCEDURE

1. REMOVE NO. 2 CYLINDER HEAD COVER

   Click here

2. REMOVE WINDSHIELD WIPER MOTOR AND LINK

   
   

   1. Remove the windshield wiper motor and link Click here.

3. REMOVE OUTER COWL TOP PANEL

   
   
   1. 

      Text in Illustration

      *A	for LHD
      *B	for RHD

      Remove the 9 bolts and outer cowl top panel.

4. REMOVE AIR FUEL RATIO SENSOR

   Click here

5. REMOVE WIRE HARNESS CLAMP BRACKET

   
   

   1. 

      Remove the bolt and wire harness clamp bracket.

6. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

   
   

   1. 

      Remove the 3 bolts and No. 1 exhaust manifold heat insulator.

7. REMOVE NO. 2 ENGINE UNDER COVER

   
   

   1. 

      Using a clip remover, remove the 4 clips and No. 2 engine under cover.

8. REMOVE FRONT CENTER FLOOR BRACE

   

   
   

   1. Remove the 4 bolts and front center floor brace.

9. REMOVE FRONT EXHAUST PIPE ASSEMBLY

   
   

   1. Detach the clamp and disconnect the heated oxygen sensor wire harness.

   2. Disconnect the heated oxygen sensor connector.

   3. 

      Remove the 2 bolts and 2 compression springs.

   4. 

      Remove the 2 bolts and 2 compression springs.

   5. Remove the 2 exhaust pipe supports and front exhaust pipe assembly.

10. REMOVE MANIFOLD STAY

    
    

    1. 

       Remove the 3 bolts and manifold stay.

11. REMOVE EXHAUST MANIFOLD

    
    

    1. 

       Remove the 5 nuts and exhaust manifold.

    2. Remove the exhaust manifold gasket.

12. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

    
    

    1. 

       Remove the 4 bolts and No. 2 exhaust manifold heat insulator.