INTAKE MANIFOLD REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. DRAIN ENGINE COOLANT

    Click here

  3. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  7. REMOVE V-RIBBED BELT

    Click here

  8. REMOVE GENERATOR ASSEMBLY

    Click here

  9. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  10. REMOVE THROTTLE BODY ASSEMBLY

    Click here

  11. REMOVE VACUUM SENSOR ASSEMBLY

    A0054IZ

    1. Disconnect the vacuum sensor connector.

    2. Remove the bolt and vacuum sensor.

    3. Disconnect the air hose from the vacuum sensor.

  12. REMOVE NO. 1 VACUUM SWITCHING VALVE ASSEMBLY

    A0053I5

    1. Disconnect the connector and 2 vacuum hoses.

    2. Remove the bolt and vacuum switching valve.

  13. REMOVE INTAKE MANIFOLD


    1. A0058WM

      Remove the bolt and wire harness clamp bracket.

    2. Detach the 5 clamps and wire harness from the intake manifold.

    3. A0056S4

      Disconnect the fuel vapor feed hose and ventilation hose.

    4. A00530W

      Remove the 5 bolts, 2 nuts, intake manifold stay and intake manifold.

    5. A00593V

      Remove the gasket from the intake manifold.

    6. A0054OX

      Remove the bolt and wire harness clamp bracket from the intake manifold.

    7. w/ Stud Bolt:


      1. Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.

  14. REMOVE NO. 1 GAS FILTER

    A00571K

    1. Disconnect the air hose from the gas filter and intake manifold.

    2. Using a 24 mm deep socket wrench, remove the gas filter from the intake manifold.

  15. REMOVE ENGINE COVER JOINT


    1. Remove the engine cover joint.