FUEL INJECTOR REMOVAL

PROCEDURE


  1. DISCHARGE FUEL SYSTEM PRESSURE


    1. Discharge fuel system pressure Click here.

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  3. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  8. DISCONNECT ENGINE WIRE


    1. A00546D

      Remove the 2 bolts and disconnect the ground wires.

    2. Disconnect the 4 fuel injector connectors.

    3. Disconnect the 2 wire harness clamps.

    4. A0057G5

      Disconnect the 4 wire harness clamps.

    5. A0057QP

      Remove the 2 bolts and 2 wire harness brackets.

  9. REMOVE AIR TUBE


    1. Disconnect the fuel vapor feed hose from the purge VSV.

    2. Disconnect the union to connector tube hose.

    3. A0058BJ

      Disconnect the No. 1 vacuum transmitting hose and No. 1 fuel vapor feed hose.

    4. Remove the 2 bolts and air tube.

  10. DISCONNECT FUEL TUBE SUB-ASSEMBLY


    1. A0058Y3E01
      Text in Illustration
      *1 Claw

      Remove the No. 2 fuel pipe clamp.

    2. A0054B6E01
      *1 Retainer

      Wipe off any dirt on the fuel tube connector.

    3. Hold the fuel tube connector and install SST.

      SST
      09268-21010

    4. Turn SST to align the retainer inside the fuel tube connector with the chamfered part of SST.

    5. Insert SST into the fuel tube and hold it. Then push the fuel tube connector toward SST.

    6. Mount the retainer of the fuel tube connector onto the chamfered part of SST.

    7. A0054T3E67
      Text in Illustration
      *1 O-Ring
      *2 Retainer
      *3 Pipe
      *4 Nylon Tube
      *5 Fuel Tube Connector

      Slide SST and the fuel tube connector together towards the fuel tube until they make a "click" sound, and then disconnect the fuel tube.

    8. Drain the fuel remaining inside the fuel tube.

    9. Cover the fuel tube and fuel pipe with a plastic bag to protect the disconnected parts.

  11. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY


    1. A0054OH

      Remove the bolt and wire harness bracket.

    2. A00535V

      Remove the 2 bolts.

    3. A00574T

      Remove the bolt and fuel delivery pipe.

    4. A0052EO

      Remove the 2 No. 1 delivery pipe spacers.

  12. REMOVE FUEL INJECTOR ASSEMBLY


    1. A00543R

      Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.

    2. A00584E

      For reinstallation, attach a tag or label to the injector shaft.

      Note

      Prevent entry of foreign objects by covering the fuel injector with plastic bags.

    3. A0052FN

      Remove the 4 injector vibration insulators.