FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  3. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE NO. 1 ENGINE UNDER COVER (for Rough Road Area Specification Vehicles)

    Click here

  6. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  7. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  8. REMOVE V-RIBBED BELT

    Click here

  9. REMOVE CRANKSHAFT PULLEY


    1. A0058UOE01
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      09330-00021

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A005743E01
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply lubricant to the threads and end of SST.

  10. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A005950E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, pry out the oil seal.

      Tech Tips

      Tape the screwdriver tip before use.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.