REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE


    1. Remove the engine assembly with transaxle Click here.

  2. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY


    1. Remove the continuously variable transaxle assembly Click here.

  3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A0054Q3E01

      Using SST, hold the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      09330-00021

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A0053ZO

      Remove the 8 bolts, rear spacer, drive plate and front spacer.

  4. REMOVE ENGINE REAR OIL SEAL


    1. A0052QCE02
      Text in Illustration
      *1 Cut Position
      *2 Protective Tape

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.