FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  3. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  5. REMOVE REAR ENGINE UNDER COVER RH

    Click here

  6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

    Click here

  7. REMOVE V-RIBBED BELT

    Click here

  8. REMOVE CRANKSHAFT PULLEY


    1. A0058UOE01
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      SST
      09213-58014   ( 91551-80840 )
      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      SST
      09213-54015
      09330-00021

      Tech Tips

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

    2. A005743E01
      Text in Illustration
      *1 Hold
      *2 Turn

      Using SST and the pulley bolt, remove the crankshaft pulley and pulley bolt.

      SST
      09950-50013   ( 09951-05010, 09952-05010, 09953-05020, 09954-05021 )

      Tech Tips

      Apply lubricant to the threads and end of SST.

  9. REMOVE TIMING CHAIN COVER OIL SEAL


    1. A005950E01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, pry out the oil seal.

      Tech Tips

      Tape the screwdriver tip before use.

      Note


      • Do not damage the surface of the oil seal press fit hole or the crankshaft.

      • After removing the oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.