CRANKSHAFT POSITION SENSOR INSTALLATION

PROCEDURE


  1. INSTALL CRANKSHAFT POSITION SENSOR


    1. A00532M

      Apply a light coat of engine oil to the O-ring of the sensor.

    2. A0057PO

      Install the sensor with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      Note

      Make sure that the O-ring is not cracked or jammed during installation.

    3. Connect the sensor connector.

  2. INSTALL REAR ENGINE UNDER COVER RH

    Click here