INTEGRATION RELAY REMOVAL

PROCEDURE


  1. REMOVE ECM


    1. Remove the ECM Click here.

  2. REMOVE FRONT FENDER LINER LH

    Click here

  3. REMOVE NO. 1 RELAY BLOCK COVER

  4. DISCONNECT WIRE HARNESS


    1. A00594U

      Remove the 2 nuts from the engine room No. 1 relay block.

    2. Disconnect the 3 connectors, detach the 2 clamps from the engine room relay block and disconnect the wire harness.

  5. DISCONNECT RELAY BLOCK


    1. A0054LJ

      for LHD:

      Disconnect the wireless door lock buzzer connector.

    2. A0055W5

      Disconnect the front speed sensor connector.

    3. A0054JIE05

      Disconnect the 2 wire harness clamps.

    4. Remove the 3 bolts.

    5. Detach the claw and guide, and slide the relay block to the inside of the engine compartment.

      Text in Illustration
      *1 Guide
      *2 Clamp

      Note

      Do not forcibly pull the relay block as the wire harness is connected.

    6. A0053HK

      Detach the 10 claws and separate the relay block cover upper side and lower side.

    7. A0059H9

      Detach the 4 claws and remove the wire harness cover.

  6. REMOVE INTEGRATION NO.1 RELAY


    1. A00535B

      Detach the 2 claws and pull the integration relay out from the relay block.

      Tech Tips

      By unraveling the wire harness indicated by the circle in the illustration, the integration relay is easier to pull out.

    2. Disconnect the 3 connectors and remove the integration relay.