MANUAL TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE


    1. for 3ZR-FAE:

      Remove the engine assembly with transaxle Click here.

    2. for 3ZR-FE:

      Remove the engine assembly with transaxle Click here.

  2. REMOVE STARTER ASSEMBLY


    1. for 3ZR-FAE:

      Remove the starter assembly Click here.

    2. for 3ZR-FE:

      Remove the starter assembly Click here.

  3. REMOVE ENGINE WIRE

    A00537R

    1. Remove the 2 bolts and engine wire.

  4. REMOVE MANUAL TRANSAXLE ASSEMBLY


    1. A0056ML

      Disconnect the back-up light switch connector and remove the bolt and wire harness from the manual transaxle.

    2. A0054TT

      Disconnect the neutral position switch connector and remove the 2 bolts, clamp and wire harness from the manual transaxle.

    3. A0056FS

      Remove the 8 bolts and manual transaxle.

  5. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. A0053FI

      Remove the 4 bolts and front engine mounting bracket.

  6. REMOVE ENGINE MOUNTING BRACKET LH


    1. A0055IN

      Remove the 4 bolts and engine mounting bracket LH.

  7. REMOVE REAR ENGINE MOUNTING BRACKET


    1. A0056FF

      Remove the 4 bolts and rear engine mounting bracket.

  8. REMOVE CLUTCH RELEASE BLEEDER TUBE

    Click here

  9. REMOVE CLUTCH FLEXIBLE HOSE BRACKET


    1. A00598O

      Remove the bolt and clutch flexible hose bracket from the manual transaxle.

  10. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click here

  11. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click here

  12. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY


    1. A00557O

      Remove the bolt and speedometer driven hole cover sub-assembly from the transaxle case.

    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.