MANUAL TRANSAXLE ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Note

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.

PROCEDURE


  1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE


    1. for 1ZR-FAE:

      Remove the engine assembly with transaxle Click here.

    2. for 2ZR-FAE:

      Remove the engine assembly with transaxle Click here.

  2. REMOVE STARTER ASSEMBLY


    1. for 1ZR-FAE:

      Remove the starter assembly Click here.

    2. for 2ZR-FAE:

      Remove the starter assembly Click here.

  3. REMOVE ENGINE WIRE

    A0055H1

    1. Remove the 2 bolts and engine wire.

  4. REMOVE MANUAL TRANSAXLE ASSEMBLY


    1. A0053E6

      Disconnect the back-up light switch connector and remove the bolt and wire harness from the manual transaxle.

    2. A0052PQ

      Disconnect the neutral position switch connector and remove the 2 bolts and wire harness from the manual transaxle.

    3. A00561C

      Remove the 7 bolts and manual transaxle.

  5. REMOVE FRONT ENGINE MOUNTING BRACKET


    1. A00568B

      Remove the 4 bolts and front engine mounting bracket.

  6. REMOVE ENGINE MOUNTING BRACKET LH


    1. A0052BP

      Remove the 4 bolts and engine mounting bracket LH.

  7. REMOVE REAR ENGINE MOUNTING BRACKET


    1. A0056YY

      Remove the 4 bolts and rear engine mounting bracket.

  8. REMOVE CLUTCH RELEASE BLEEDER TO FLEXIBLE HOSE TUBE


    1. A0054YZ

      for 1ZR-FAE:


      1. Remove the bolt and disconnect the clamp.

      2. Using a union nut wrench, remove the clutch release bleeder to flexible hose tube from the clutch release bleeder sub-assembly.

    2. A0052TN

      for 2ZR-FAE:


      1. Remove the 2 bolts and disconnect the 2 clamps.

      2. Using a union nut wrench, remove the clutch release bleeder to flexible hose tube from the clutch release bleeder sub-assembly.

  9. REMOVE CLUTCH FLEXIBLE HOSE BRACKET


    1. A0052T8

      Remove the bolt and clutch flexible hose bracket from the manual transaxle.

  10. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    Click here

  11. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY

    Click here

  12. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY


    1. A00556X

      Remove the bolt and speedometer driven hole cover sub-assembly from the transaxle case.

    2. Remove the O-ring from the speedometer driven hole cover sub-assembly.