MANUAL TRANSAXLE OIL REPLACEMENT

PROCEDURE


  1. REMOVE ENGINE UNDER COVER


    1. A005759

      except Rough Road Area Specification Vehicles:

      Remove the 8 clips and fold back the engine under cover.

      Tech Tips

      It is not necessary to fully remove the engine under cover. Partially remove it so that the oil can be replaced in a later step.

  2. REMOVE FRONT LOWER BUMPER ABSORBER (for Rough Road Area Specification Vehicles)

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER (for Rough Road Area Specification Vehicles)

    Click here

  4. DRAIN MANUAL TRANSAXLE OIL


    1. A0058HZE04
      Text in Illustration
      *1 Filler Plug
      *2 Drain Plug

      Remove the filler plug and gasket.

    2. Remove the drain plug and gasket to drain the manual transaxle oil.

    3. Install a new gasket and the drain plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

  5. ADD MANUAL TRANSAXLE OIL


    1. A0059LO

      Add oil until the oil level is within 5 mm (0.197 in.) from the bottom of the transmission filler plug opening.

      Manual Transaxle Gear Oil
      TOYOTA Genuine Manual Transmission Gear Oil LV or equivalent
      Oil Classification
      API GL-4 and SAE 75W
      Capacity
      2.4 liters (2.5 US qts, 2.1 Imp. qts)

    2. Install a new gasket and the transmission filler plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

      Note


      • When adding transaxle oil, make sure the vehicle is level.

      • An excessively large or small amount of oil may cause problems.

      • After adding oil, drive the vehicle and recheck the oil level.

  6. INSPECT FOR OIL LEAK

  7. INSTALL NO. 1 ENGINE UNDER COVER (for Rough Road Area Specification Vehicles)

    Click here

  8. INSTALL FRONT LOWER BUMPER ABSORBER (for Rough Road Area Specification Vehicles)

    Click here

  9. INSTALL ENGINE UNDER COVER

    A0056LB

    1. except Rough Road Area Specification Vehicles:

      Install the engine under cover with the 8 clips.