CLUTCH UNIT(for EB60) REMOVAL

CAUTION / NOTICE / HINT

Note

When the transaxle is removed, be sure to use a new clutch release with bearing cylinder and new installation bolts. Removal of the transaxle allows the compressed clutch release with bearing cylinder to return to its original position, and dust could damage the seal of the clutch release with bearing cylinder, possibly causing clutch fluid leaks.

PROCEDURE


  1. REMOVE MANUAL TRANSAXLE ASSEMBLY


    1. Remove the manual transaxle assembly Click here.

  2. REMOVE CLUTCH RELEASE BLEEDER TUBE


    1. A0052PBE02

      Using a 10 mm union nut wrench, loosen the clutch release bleeder tube labeled A.

    2. Remove the bolt, clamp and clutch release bleeder tube.

  3. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY

    A0053H4

    1. Using a union nut wrench, separate the clutch release bleeder sub-assembly from the clutch release cylinder to bleeder tube.

    2. Remove the 2 bolts and clutch release bleeder sub-assembly from the manual transaxle assembly.

  4. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY


    1. A005867

      Remove the clutch tube boot from the manual transaxle assembly.

    2. A0055W8

      Remove the 3 bolts and clutch release with bearing cylinder assembly and clutch release cylinder to bleeder tube.

    3. A0058E8

      Using a union nut wrench, remove the clutch release cylinder to bleeder tube from the clutch release with bearing cylinder assembly.

  5. REMOVE CLUTCH COVER ASSEMBLY

    A0059KIE04
    Text in Illustration
    *1 Matchmark

    1. Put matchmarks on the clutch cover assembly and flywheel sub-assembly.

    2. Loosen each set bolt one turn at a time in the order shown in the illustration until the spring tension is released.

    3. Remove the set bolts and pull off the clutch cover assembly.

      Note

      Do not drop the clutch disc assembly.

  6. REMOVE CLUTCH DISC ASSEMBLY