OIL COOLER INSTALLATION

PROCEDURE


  1. INSTALL NO. 2 OIL COOLER TUBE SUB-ASSEMBLY


    1. A00535OE02
      Text in Illustration
      *1 White Paint Mark
      *2 Yellow Paint Mark

      Connect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose to the No. 2 oil cooler tube.

      Note

      Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

    2. Install the No. 2 oil cooler tube sub-assembly to the radiator with the 2 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Connect the No. 3 oil cooler inlet hose and No. 3 oil cooler outlet hose to the radiator.

      Note

      Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

  2. INSTALL NO. 1 OIL COOLER TUBE SUB-ASSEMBLY


    1. A00540OE02
      Text in Illustration
      *1 Yellow Paint Mark
      *2 Blue Paint Mark

      Connect the No. 1 oil cooler inlet hose, No. 1 oil cooler outlet hose, No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose to the No. 1 oil cooler tube.

      Note

      Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

    2. A005349E02
      Text in Illustration
      *1 Yellow Paint Mark

      Install the No. 1 oil cooler tube sub-assembly with the bolt.

      Torque:
      12 N*m  { 117 kgf*cm, 8 ft.*lbf }

    3. Connect the No. 1 oil cooler inlet hose and No. 1 oil cooler outlet hose to the automatic transaxle.

      Note

      Make sure the paint marks and pinching portion of each clip are facing the direction shown in the illustration.

    4. A005636E02
      Text in Illustration
      *1 Yellow Paint Mark
      *2 Printed Mark

      Connect the No. 2 oil cooler inlet hose and No. 2 oil cooler outlet hose to the No. 2 oil cooler tube.

      Note

      Make sure the pinching portion of each clip is facing the direction shown in the illustration and the paint marks are aligned as shown in the illustration.

  3. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  4. INSTALL FRONT LOWER BUMPER ABSORBER

    Click here

  5. INSTALL BATTERY CARRIER

    Click here

  6. INSTALL BATTERY

    Click here

  7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. ADD AUTOMATIC TRANSAXLE FLUID

    Fluid type
    Toyota Genuine ATF WS

  9. INSPECT AUTOMATIC TRANSAXLE FLUID LEVEL


    1. Inspect the transaxle fluid level Click here.

  10. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here