PARK / NEUTRAL POSITION SWITCH INSTALLATION

PROCEDURE


  1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    A0053UI

    1. Install the park/neutral position switch to the manual valve shaft.

    2. Temporarily install the 2 bolts.

    3. A0055IU

      Install a new lock plate and the lock nut.

      Torque:
      6.9 N*m  { 70 kgf*cm, 61 in.*lbf }

    4. Temporarily install the control shaft lever.

    5. A0057H7E03

      Turn the lever counterclockwise until it stops, and then turn it clockwise 2 notches.

    6. Remove the control shaft lever.

    7. A0059F3E14
      Text in Illustration
      *1 Neutral Basic Line
      *2 Protrusion

      Align the groove with the neutral basic line.

    8. Hold the switch in this position and tighten the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    9. A0055ZM

      Using a screwdriver, bend the tabs of the lock plate.

    10. A00572Q

      Install the control shaft lever with the washer and nut.

      Torque:
      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

  2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    A0057Q5

    1. Connect the transmission control cable to the control shaft lever with the nut.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }
    2. A005507

      Connect the park/neutral position switch connector.

  3. INSTALL BATTERY CARRIER

    Click here

  4. INSTALL BATTERY

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. INSTALL RADIATOR SUPPORT OPENING COVER

    Click here

  7. INSPECT SHIFT LEVER POSITION

    Click here

  8. ADJUST SHIFT LEVER POSITION

    Click here

  9. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    Click here