PARK / NEUTRAL POSITION SWITCH REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY

    Click here

  5. REMOVE BATTERY CARRIER

    Click here

  6. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

    A0057Q5

    1. Remove the nut and disconnect the control cable from the control shaft lever.

  7. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY

    A005507

    1. Disconnect the park/neutral position switch connector.

    2. A00572Q

      Remove the nut, washer and control shaft lever.

    3. A0055ZM

      Using a screwdriver, bend the tabs of the lock plate.

    4. Remove the lock nut and lock plate.

    5. A0053UI

      Remove the 2 bolts and pull out the park/neutral position switch to remove it.