TRANSMISSION WIRE REMOVAL

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE BATTERY

    Click here

  5. REMOVE BATTERY CARRIER

    Click here

  6. REMOVE FRONT LOWER BUMPER ABSORBER

    A0057MI

    1. Remove the 2 screws and 4 bolts.

    2. A0057NY

      Remove the 3 screws, 8 bolts and front lower bumper absorber.

  7. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  8. DRAIN AUTOMATIC TRANSAXLE FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      49 N*m  { 500 kgf*cm, 36 ft.*lbf }

  9. REMOVE AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

    A0052PA

    1. Remove the 18 bolts, oil pan and gasket.

      Note

      Some fluid will remain in the oil pan. Carefully remove the oil pan.

    2. Remove the 2 magnets from the oil pan.

    3. A0056KM

      Examine particles in the pan.


      1. Use the removed magnets to collect any steel chips. Look carefully at the chips and particles in the pan and on the magnet to anticipate what type of wear you will find in the transaxle.

        Steel (magnetic): bearing, gear and plate wear

        Brass (non-magnetic): bush wear

  10. DISCONNECT TRANSMISSION WIRE

    A0058UKE03
    Text in Illustration
    *1 Lock Plate

    1. Disconnect the 5 shift solenoid valve connectors.

    2. Remove the bolt, lock plate and ATF temperature sensor.

  11. REMOVE TRANSMISSION WIRE

    A0055LI

    1. Disconnect the transmission wire connector.

    2. Remove the bolt and transmission wire.

    3. A0052HJE02

      Remove the O-ring from the transmission wire.