STARTER REMOVAL

PROCEDURE


  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  3. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE FRONT LOWER BUMPER ABSORBER

    Click here

  6. REMOVE NO. 1 ENGINE UNDER COVER

    Click here

  7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  8. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    Click here

  9. REMOVE BATTERY

  10. REMOVE BATTERY TRAY

  11. REMOVE BATTERY CARRIER

    Click here

  12. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for CVT)


    1. A0059AI

      Remove the clip and disconnect the control cable assembly from the control cable bracket.

  13. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for CVT)

    Click here

  14. REMOVE STARTER ASSEMBLY


    1. A0056F3

      Disconnect the terminal cap.

    2. Remove the nut and disconnect the starter wire.

    3. Disconnect the connector.

    4. Remove the 2 bolts and starter.

  15. REMOVE FLYWHEEL HOUSING SIDE COVER


    1. A0058YN

      Remove the flywheel housing side cover from the cylinder block.