СТАРТЕР УСТАНОВКА


  1. INSTALL STARTER ASSEMBLY


    1. Install the starter assembly with the 2 bolts and nut.

      Torque:
      68 N*m  { 693 kgf*cm, 50 ft.*lbf }

    2. Connect the starter wire with the nut.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    3. Install the terminal cap.

    4. Connect the starter connector.

  2. CONNECT CLUTCH FLEXIBLE HOSE BRACKET


    1. Connect the clutch flexible hose bracket with the bolt.

      Torque:
      72 N*m  { 730 kgf*cm, 53 ft.*lbf }

  3. CONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


    1. Подсоедините рабочий цилиндр с помощью 2 болтов.

      Torque:
      12 Н*м  { 120 кгс*см, 9 фунт-сила-футов }

  4. INSTALL REAR ENGINE UNDER COVER ASSEMBLY


    1. Установите заднюю защиту картера двигателя и закрепите ее 4 болтами.

      Torque:
      29 Н*м  { 296 кгс*см, 21 фунт-сила-фут }

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.