СВЕЧА НАКАЛИВАНИЯ СНЯТИЕ


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note


    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  2. REMOVE RESONATOR WITH AIR CLEANER CAP SUB-ASSEMBLY


    1. A01DTKZ

      Отсоедините разъем датчика.

    2. Освободите зажим жгута проводов.

    3. Ослабьте зажим шланга и снимите резонатор с крышкой воздушного фильтра.

    4. A01DNS4

      Открепите 4 откидных защелки, а затем снимите крышку воздушного фильтра и резонатор с крышкой воздушного фильтра.

  3. REMOVE INTAKE PIPE


    1. A01DO3X

      Remove the 2 bolts.

    2. Loosen the hose clamp and remove the intake pipe.

  4. DISCONNECT VENTILATION HOSE


    1. A01DOBE

      Disconnect the ventilation hose.

  5. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. A01DR1H

      Remove the nut, No. 2 glow plug resistor insulator and washer and disconnect the wire harness.

    2. Remove the 4 screw grommets and 4 nuts.

    3. Remove the No. 1 glow plug connector and No. 1 glow plug resistor insulator.

  6. REMOVE GLOW PLUG ASSEMBLY


    1. A01DLUU

      Using a 12 mm deep socket wrench, remove the 4 glow plugs.