Click here

ЗАДНИЙ САЛЬНИК КОЛЕНЧАТОГО ВАЛА СНЯТИЕ

Click here
Click here Click here
  1. Click here

    REMOVE MANUAL TRANSMISSION ASSEMBLY


    1. Remove the manual transmission (Click here).

  2. Click here

    REMOVE CLUTCH COVER ASSEMBLY


    1. A01DSECE01

      Place matchmarks on the clutch cover and flywheel.

      Table 1. Text in Illustration
      *a Matchmark

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the 6 set bolts and pull off the clutch cover.

      Note:

      Do not drop the clutch disc.

  3. Click here

    REMOVE CLUTCH DISC ASSEMBLY

    Note:

    Keep the lining part of the clutch disc, the pressure plate and the surface of the flywheel away from oil and foreign matter.

  4. Click here

    REMOVE FLYWHEEL SUB-ASSEMBLY


    1. Зафиксируйте коленчатый вал с помощью SST.

      09213-54015 91651-60855
      09330-00021

    2. Выверните 8 болтов и снимите маховик.

  5. Click here

    REMOVE REAR END PLATE


    1. Выверните 2 болта и снимите заднюю крышку.

  6. Click here

    REMOVE FLYWHEEL HOUSING DUST SEAL

  7. Click here

    REMOVE REAR CRANKSHAFT OIL SEAL


    1. A01DQL6E03

      Using a knife, cut off the lip of the oil seal.

      Table 2. Text in Illustration
      *a Cut Position

    2. Using a screwdriver, pry out the oil seal.

      Note:

      After the removal, check that the crankshaft is not damaged. If damaged, repair it with a sandpaper (#400).

      Tip:

      Tape the screwdriver before use.