STOP LIGHT SWITCH INSTALLATION


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. A01HUYX

      Insert the stop light switch assembly until the threaded sleeve hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. A01HT5DE01

      Make a quarter turn clockwise to install the stop light switch assembly.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf, or less }

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the plunger.

      Protrusion of the plunger
      Area Measurement
      a 1.5 to 2.5 mm (0.0591 to 0.0984 in.)

      If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary Click here.

      Note

      Do not depress or support the brake pedal.