OUTER REAR VIEW MIRROR COVER REMOVAL

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.


  1. REMOVE OUTER REAR VIEW MIRROR (w/o Retract Mirror)


    1. A01HT1TE01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the areas shown in the illustration.

    2. Push the lower part of the mirror surface and tilt it.

    3. A01HTRTE01
      Text in Illustration
      *1 Moulding Remover

      Using a moulding remover, disengage the 2 claws at the upper part of the outer rear view mirror as shown in the illustration.

    4. A01HU19

      Disengage the 2 guides and remove the outer rear view mirror as shown in the illustration.

    5. w/ Mirror Heater:


      1. A01HTKQ

        Disconnect the 2 connectors and remove the outer rear view mirror.

    6. w/ Mirror Heater and Blind Spot Monitor System:


      1. Disconnect the 2 mirror heater connectors.

      2. Disengage the 2 claws.

      3. A01HSNSE01
        Text in Illustration
        *1 Mirror Heater Connector
        *2 Blind Spot Monitor Indicator Connector

        Using a screwdriver, release the tabs of the blind spot monitor indicator connector to disconnect the connector and remove the outer rear view mirror.

        Note


        • Do not bend the tabs excessively to prevent them from being damaged.

        • If the tabs are damaged, replace the outer rear view mirror with a new one.

  2. REMOVE OUTER REAR VIEW MIRROR (w/ Retract Mirror)


    1. A01HT1RE01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the areas shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. A01HSRPE01
      Text in Illustration
      *1 Moulding Remover

      Using a moulding remover, disengage the 2 claws at the lower part of the outer rear view mirror as shown in the illustration.

    4. A01HT5F

      Disengage the 2 guides as shown in the illustration.

    5. A01HW92

      Disconnect the 2 connectors and remove the outer rear view mirror.

  3. REMOVE OUTER MIRROR COVER (w/o Retract Mirror)


    1. A01HW5A

      Disengage the 8 claws and remove the outer mirror cover.

  4. REMOVE OUTER MIRROR COVER (w/ Retract Mirror)


    1. A01HSXM

      Remove the 3 screws.

    2. A01HVUD

      Disengage the clamp.

    3. Disconnect the 2 connectors and remove the mirror actuator.

    4. A01HTKO

      Disengage the 7 claws and remove the outer mirror cover.