SLIDING ROOF HOUSING DISASSEMBLY


  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A01HW7NE01
      Text in Illustration
      *1 Guide
      *2 Pin

      Disengage the claw.

    2. Disengage the guide and pin, and remove the map light bracket.

    3. A01HTAC

      Remove the 2 bolts and sliding roof drive gear sub-assembly.

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    1. A01HTWL

      Remove the screw and sliding roof piece sub-assembly LH.

      Tech Tips

      Use the same procedure for the RH side.

    2. A01HTCX

      Slide and remove the sunshade trim sub-assembly.

  3. REMOVE REAR SLIDING ROOF PANEL


    1. A01HT9PE01

      Disengage the 2 claws. Then slide the rear sliding roof panel rearward to remove it.

  4. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. A01HVFM

      Hold down the roof wind deflector panel sub-assembly.

    2. A01HUHLE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, slide the sliding roof drive cable sub-assembly in the direction indicated by the arrow in the illustration to remove it.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the other sliding roof drive cable sub-assembly.

  5. REMOVE ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY


    1. A01HURJE01
      Text in Illustration
      *1 Spring
      *2 Guide

      Pull the spring in the direction indicated by the arrow (1) in the illustration to disengage the 2 springs.

    2. Pull the roof wind deflector panel sub-assembly in the direction indicated by the arrow (2) in the illustration to disengage the 2 guides and remove it.