FRONT SEAT ASSEMBLY (for Manual Seat) REMOVAL


  1. PRECAUTION

    CAUTION:


    • Be sure to read Precaution thoroughly before servicing Click here.

    • If the side airbag was deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    1. A01HUM2

      Disengage the claw to remove the luggage trim service hole cover.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE FRONT SEAT HEADREST ASSEMBLY

  5. REMOVE REAR OUTER SEAT TRACK BRACKET COVER


    1. Lift up the seat track adjusting handle and move the seat to the foremost position.

    2. A01HW0H

      Disengage the 2 claws and remove the rear outer seat track bracket cover.

  6. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    1. A01HUY6

      Disengage the 2 claws and remove the rear inner seat track bracket cover.

  7. REMOVE FRONT SEAT ASSEMBLY


    1. A01HTQM

      Remove the 2 bolts on the rear side of the seat.

    2. Lift up the seat track adjusting handle and move the seat to the rearmost position.

    3. Remove the 2 bolts on the front side of the seat.

    4. Disconnect each connector and clamp under the seat.

    5. Lift up the seat track adjusting handle and move the seat to the center position. Then, operate the reclining adjuster release handle and move the seatback to the upright position.

    6. Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.