KNEE AIRBAG ASSEMBLY (for Front Passenger Side) INSTALLATION

INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

Text in Illustration
*1	Airbag Connector
*2	Airbag Connector Lock

Connect the airbag connector to the lower No. 2 instrument panel airbag assembly.

Note

When connecting any airbag connector, take care not to damage the airbag wire harness.

Push in the lock to install the airbag connector.
Temporarily install the lower No. 2 instrument panel airbag assembly with the 3 claws.
Install the 3 bolts.

Torque:

10 N*m { 102 kgf*cm, 7 ft.*lbf }

Note

Confirm that the lower No. 2 instrument panel airbag assembly is installed securely without any excessive gaps and is not protruding outward.

INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
1. Connect the connector.
2. Engage the 2 guides and 4 claws to install the No. 2 instrument panel under cover sub-assembly.
INSTALL INSTRUMENT SIDE PANEL RH
1. Engage the 3 guides.
2. Engage the 4 claws to install the instrument side panel RH as shown in the illustration.
CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

Tech Tips

Use the same procedure for the RH side and LH side Click here.
INSTALL FRONT DOOR SCUFF PLATE RH

Tech Tips

Use the same procedure for the RH side and LH side Click here.
CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

Note

When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
INSTALL LUGGAGE TRIM SERVICE HOLE COVER
1. Engage the claw to connect the luggage trim service hole cover.
PERFORM DIAGNOSTIC SYSTEM CHECK

Click here
INSPECT SRS WARNING LIGHT

Click here