CURTAIN SHIELD AIRBAG ASSEMBLY INSTALLATION

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly with the 2 hooks.

      A01HTPUE01

      Note


      • When installing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.

      • Do not twist the curtain shield airbag assembly when installing it.

    4. Install 2 new bolts in the order shown in the illustration.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

    5. Install the curtain shield airbag assembly to the body panel with 5 claws, 6 new clips and 2 new spacers in the order shown in the illustration.

      A01HW64E01
      Text in Illustration
      *1 Pin *2 Clip
      *3 Curtain Shield Airbag Assembly *4 Body Panel
      *5 Spacer - -
    6. A01HT5W

      Push in a new pin to each clip.

      Note

      Make sure that the pins of the clips are pushed in firmly.

    7. A01HVWZE01
      Text in Illustration
      *1 Airbag Connector
      *2 Airbag Connector Lock

      Connect the curtain shield airbag connector.

      Note

      When connecting any airbag connector, take care not to damage the airbag wire harness.

    8. Push in the lock to install the curtain shield airbag connector.

  2. INSTALL ROOF HEADLINING ASSEMBLY

    Click here

  3. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here