GARAGE DOOR OPENER SYSTEM ON-VEHICLE INSPECTION


  1. INSPECT GARAGE DOOR OPENER


    1. A01HTT9E02
      Text in Illustration
      *1 Garage Door Opener Switch
      *2 LED

      To inspect the garage door opener system, press each switch and check that the LED in the "HomeLink" logo illuminates as illustrated. If one or more of the switches do not cause the LED to illuminate, confirm that the fuse and the wiring to the garage door opener transmitter are normal. If the fuse and wiring are normal, and the LED does not illuminate, replace the garage door opener transmitter that is located in the roof console box assembly.

  2. INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING

    Tech Tips

    Use the KENT-MOORE "HomeLink" tester, and the KENT-MOORE handheld transmitter for this test. First clear the customer's transmitter codes, and then register the code of the KENT-MOORE handheld transmitter to the garage door opener system.


    1. A01HSGXE01
      Text in Illustration
      *1 Handheld Transmitter
      *a Press

      Check if the code of the KENT-MOORE handheld transmitter was successfully registered.

      Tech Tips

      If the code of the KENT-MOORE handheld transmitter cannot be registered, replace the garage door opener transmitter located in the roof console box assembly.

    2. A01HSCBE01
      Text in Illustration
      *1 Handheld Transmitter
      *2 "HomeLink" Tester
      *3 Green LED
      *a Press

      Press the garage door opener switch that was used to copy the signal from the handheld transmitter. Check if the green LED of the "HomeLink" tester illuminates.

      Tech Tips

      If the green LED does not illuminate, replace the garage door opener transmitter that is located in the map light assembly.

    3. When the inspection is complete, re-register the customer's handheld transmitter codes.