BLIND SPOT MONITOR MAIN SWITCH INSTALLATION


  1. INSTALL BLIND SPOT MONITOR MAIN SWITCH ASSEMBLY (WARNING CANCELING SWITCH ASSEMBLY)


    1. Engage the 2 claws to install the blind spot monitor main switch assembly (warning canceling switch assembly).

  2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A01HTMC

      Temporarily install the instrument cluster finish panel assembly as shown in the illustration.

    2. Connect each connector.

    3. Engage the 5 claws, 5 clips and 2 guides, and install the instrument cluster finish panel assembly.

    4. A01HSML

      Engage the 2 claws, 4 clips and 2 guides.

  3. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HSH8

      Engage the 4 clips to install the No. 1 instrument panel register assembly.

  4. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A01HTAL

      Engage the 3 clips to install the No. 1 instrument cluster finish panel garnish.

  5. INSTALL INSTRUMENT SIDE PANEL LH


    1. Engage the 3 guides.

    2. A01HSIH

      Engage the 4 claws to install the instrument side panel LH as shown in the illustration.

  6. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    1. A01HV13E01
      Text in Illustration
      *1 Alignment Mark (Yellow)

      Align the alignment mark (Yellow) on the weatherstrip with the protruding portion on the body indicated by the arrow in the illustration, and install the front door opening trim weatherstrip LH.

      Note

      After installation, check that the corners fit correctly.