CLEARANCE SONAR MAIN SWITCH REMOVAL


  1. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH


    1. A01HSG5

      Disconnect the front door opening trim weatherstrip LH.

  2. REMOVE INSTRUMENT SIDE PANEL LH


    1. A01HTFQ

      Using a moulding remover, disengage the 4 claws as shown in the illustration.

    2. A01HT5Y

      Disengage the 3 guides and remove the instrument side panel LH as shown in the illustration.

  3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH


    1. A01HSL0

      Disengage the 3 clips to remove the No. 1 instrument cluster finish panel garnish as shown in the illustration.

  4. REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HVJKE01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the area shown in the illustration.

    2. A01HUXQ

      Disengage the 2 clips as shown in the illustration.

    3. A01HW8L

      Using a moulding remover, disengage the 2 clips to remove the No. 1 instrument panel register assembly.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. Operate the tilt and telescopic lever to fully extend and lower the steering column assembly.

    2. A01HTQ1

      Using a moulding remover, disengage the 2 claws, 4 clips and 2 guides.

    3. A01HSTJ

      Disengage the 5 claws, 5 clips and 2 guides.

    4. Disconnect each connector.

    5. A01HUIZ

      Remove the instrument cluster finish panel assembly as shown in the illustration.

  6. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY


    1. A01HW3Z

      Disengage the 2 claws and remove the back sonar or clearance sonar switch assembly.