REAR VIEW MONITOR SYSTEM HOW TO PROCEED WITH TROUBLESHOOTING

Tech Tips


  • Use the following procedure to troubleshoot the rear view monitor system.

  • *: Use the Techstream.


  1. VEHICLE BROUGHT TO WORKSHOP


    NEXT

  2. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.


      NEXT

  3. CHECK AND CLEAR DTCs*


    1. Refer to DTC Check/Clear of the navigation system or audio and visual system.


      • Refer to DTC check/clear (Navigation system for radio and display type) Click here.

      • Refer to DTC check/clear (Navigation system for navigation receiver type) Click here.

      • Refer to DTC check/clear (Audio and visual system for radio and display type without intuitive parking assist system type) Click here.


      NEXT

  4. PROBLEM SYMPTOM CONFIRMATION

    Result
    Result Proceed to
    Symptom does not occur A
    Symptom occurs (Navigation system for radio and display type) B
    Symptom occurs (Navigation system for navigation receiver type)
    Symptom occurs (Audio and visual system for radio and display type without intuitive parking assist system type)

    B

    Go to step 6
    A

  5. SYMPTOM SIMULATION


    NEXT

  6. CHECK IF SAME SYMPTOM APPEARS IN NAVIGATION SYSTEM OR AUDIO AND VISUAL SYSTEM


    1. Refer to the navigation system (for Radio and display type) Click here.

    2. Refer to the navigation system (for Navigation receiver type) Click here.

    3. Refer to the audio and visual system (for Radio and display type without intuitive parking assist system type) Click here.

      Result
      Result Proceed to
      Symptom does not appear A
      Symptom appears (follow the navigation system problem symptom table to perform troubleshooting) (for Radio and display type) B
      Symptom appears (follow the navigation system problem symptom table to perform troubleshooting) (for Navigation receiver type) C
      Symptom appears (follow the audio and visual system problem symptom table to perform troubleshooting) (for Radio and display type without intuitive parking assist system) D

      B

      GO TO NAVIGATION SYSTEM (for RADIO AND DISPLAY TYPE) Click here

      C

      GO TO NAVIGATION SYSTEM (for NAVIGATION RECEIVER TYPE) Click here

      D

      GO TO AUDIO AND VISUAL SYSTEM (for RADIO AND DISPLAY TYPE WITHOUT INTUITIVE PARKING ASSIST SYSTEM) Click here

      A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

      B

      Go to step 9
      A

  8. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM


    1. Terminals of ECU Click here


      NEXT

  9. ADJUST, REPAIR OR REPLACE


    NEXT

  10. CONFIRMATION TEST


    NEXT
    END