NAVIGATION RECEIVER REMOVAL


  1. PRECAUTION

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    1. A01HUM2

      Disengage the claw to remove the luggage trim service hole cover.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  5. REMOVE BOX BOTTOM MAT


    1. A01HURY

      Remove the box bottom mat.

  6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01HV5K

      Remove the 2 screws <D> or <E>.

    2. A01HV6V

      Disengage the 4 clips and guide as shown in the illustration.

    3. Disconnect each connector to remove the upper console panel sub-assembly.

  7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A01HW8T

      Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

    2. A01HSUT

      Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

    3. A01HVNV

      Disengage the 3 claws and 2 clips as shown in the illustration.

    4. A01HSZ6

      Disengage the clamp.

    5. Disconnect the connector to remove the center instrument cluster finish panel assembly.

  8. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HTS7

      Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 6 clips to remove the No. 2 instrument panel register assembly.

  9. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    1. A01HTGG

      Apply protective tape to the areas shown in the illustration.

      Text in Illustration
      A01HVUW Protective Tape
    2. A01HU78

      Remove the 4 bolts.

    3. A01HV5C

      Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.

    4. Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.

  10. REMOVE NO. 1 RADIO BRACKET


    1. w/o Satellite Radio:


      1. A01HSN0

        Remove the 5 screws and No. 1 radio bracket.

    2. w/ Satellite Radio:


      1. A01HSZA

        Remove the 7 screws and No. 1 radio bracket.

  11. REMOVE NO. 2 RADIO BRACKET


    1. w/o Satellite Radio:


      1. A01HVDT

        Remove the 5 screws and No. 2 radio bracket.

    2. w/ Satellite Radio:


      1. A01HU7O

        Remove the 7 screws and No. 2 radio bracket.

  12. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    1. A01HSYM

      Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.

  13. REMOVE NO. 1 NAVIGATION WIRE (w/ Satellite Radio)


    1. A01HTDY

      Disconnect the 6 connectors to remove the No. 1 navigation wire.

  14. REMOVE STEREO COMPONENT TUNER ASSEMBLY (w/ Satellite Radio)

  15. REMOVE NAVIGATION RECEIVER ASSEMBLY