NAVIGATION RECEIVER REMOVAL


  1. PRECAUTION

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

    • A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the navigation receiver assembly.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER


    1. A01HUM2

      Disengage the claw to remove the luggage trim service hole cover.

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  5. REMOVE BOX BOTTOM MAT


    1. A01HURY

      Remove the box bottom mat.

  6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. A01HV5K

      Remove the 2 screws <D> or <E>.

    2. A01HV6V

      Disengage the 4 clips and guide as shown in the illustration.

    3. Disconnect each connector to remove the upper console panel sub-assembly.

  7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. A01HW8T

      Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

    2. A01HSUT

      Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.

    3. A01HVNV

      Disengage the 3 claws and 2 clips as shown in the illustration.

    4. A01HSZ6

      Disengage the clamp.

    5. Disconnect the connector to remove the center instrument cluster finish panel assembly.

  8. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HTS7

      Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 6 clips to remove the No. 2 instrument panel register assembly.

  9. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY


    1. A01HVE7E01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the areas shown in the illustration.

    2. A01HUH5

      Remove the 4 bolts.

    3. A01HSM0

      Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.

    4. Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.

  10. REMOVE NO. 1 RADIO RECEIVER BRACKET


    1. A01HSMS

      Remove the 5 screws and No. 1 radio receiver bracket.

  11. REMOVE NO. 2 RADIO RECEIVER BRACKET


    1. A01HTDS

      Remove the 5 screws and No. 2 radio receiver bracket.

  12. REMOVE AIR CONDITIONING CONTROL ASSEMBLY


    1. A01HSYM

      Disengage the 4 clips and guide, and remove the air conditioning control assembly as shown in the illustration.

  13. REMOVE HARD DISK DRIVE


    1. A01HU3W

      Remove the 2 screws.

    2. Disengage the 2 guides to remove the cover.

    3. A01HUK3

      Pull out the hard disk drive from the navigation receiver assembly or radio and display receiver assembly in the direction shown by the arrow in the illustration to remove it.

  14. REMOVE NAVIGATION COMPUTER SUB-ASSEMBLY