SATELLITE RADIO TUNER INSTALLATION


  1. INSTALL STEREO COMPONENT TUNER ASSEMBLY

  2. INSTALL NO. 1 NAVIGATION WIRE


    1. Connect the 6 connectors to install the No. 1 navigation wire.

  3. INSTALL AIR CONDITIONING CONTROL ASSEMBLY


    1. A01HT9M

      Engage the guide and 4 clips to install the air conditioning control assembly as shown in the illustration.

  4. INSTALL NO. 1 RADIO BRACKET


    1. w/o Satellite Radio:


      1. Install the No. 1 radio bracket with the 5 screws.

    2. w/ Satellite Radio:


      1. Install the No. 1 radio bracket with the 7 screws.

  5. INSTALL NO. 2 RADIO BRACKET


    1. w/o Satellite Radio:


      1. Install the No. 2 radio bracket with the 5 screws.

    2. w/ Satellite Radio:


      1. Install the No. 2 radio bracket with the 7 screws.

  6. INSTALL RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/o Navigation System)


    1. Connect each connector.

    2. Engage the 8 clips to the vehicle body to temporarily install the radio receiver assembly with air conditioning control assembly.

    3. Install the radio receiver assembly with air conditioning control assembly with the 4 bolts.

  7. INSTALL NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (w/ Navigation System)


    1. Connect each connector.

    2. Engage the 8 clips to the vehicle body to temporarily install the navigation receiver assembly with air conditioning control assembly.

    3. Install the navigation receiver assembly with air conditioning control assembly with the 4 bolts.

  8. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


    1. A01HTXM

      Engage the 6 clips to install the No. 2 instrument panel register assembly.

      Note

      When installing the No. 2 instrument panel register assembly, check that the wire harness is not caught between the No. 2 instrument panel register assembly and duct.

  9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


    1. Connect the connector.

    2. Engage the clamp.

    3. A01HW3O

      Engage the 6 clips and 7 claws to install the center instrument cluster finish panel assembly.

  10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 4 clips and guide.

    3. Install the upper console panel sub-assembly with the 2 screws <D> or <E>.

  11. INSTALL BOX BOTTOM MAT


    1. Install the box bottom mat.

  12. INSTALL REAR CONSOLE BOX ASSEMBLY

    Click here

  13. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Navigation System)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  14. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (w/ Navigation System)


    1. Engage the claw to connect the luggage trim service hole cover.