STEERING GEAR REASSEMBLY


  1. INSTALL NO. 2 STEERING RACK BOOT


    1. Wipe the old grease off of the No. 2 steering rack boot and rack end mating groove.

    2. A01HT8Y

      Apply silicone grease to the inside of the small opening of a new No. 2 steering rack boot.

    3. Install the No. 2 steering rack boot to the groove on the rack housing.

      Note


      • Be careful not to damage or twist the boot.

      • Make sure that the boot is free of rust and foreign matter.

  2. INSTALL NO. 1 STEERING RACK BOOT

    Tech Tips

    Perform the same procedure as for the No. 2 steering rack boot.

  3. INSTALL NO. 2 STEERING RACK BOOT CLAMP


    1. A01HSA9E08

      Using SST, tighten a new No. 2 steering rack boot clamp as shown in the illustration.

      SST
      09521-24010
      Clearance
      3.0 mm (0.118 in.) or less

      Note

      Be careful not to damage the No. 2 steering rack boot.

  4. INSTALL NO. 1 STEERING RACK BOOT CLAMP

    Tech Tips

    Perform the same procedure as for the No. 2 steering rack boot clamp.

  5. INSTALL STEERING RACK BOOT CLIP (for LH Side)


    1. Using pliers, install the steering rack boot clip.

  6. INSTALL STEERING RACK BOOT CLIP (for RH Side)

    Tech Tips

    Perform the same procedure as for the LH side.

  7. INSPECT STEERING GEAR ASSEMBLY


    1. A01HW5XE01

      Using SST, rotate the pinion shaft to see if both the left and the right steering rack boots expand and contract smoothly.

      SST
      09616-00020

      Tech Tips

      If the operation cannot be done as specified, use a new steering rack boot clamp and reinstall the steering rack boots.