REAR BRAKE FLEXIBLE HOSE INSTALLATION

Note


  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.


  1. INSTALL REAR FLEXIBLE HOSE


    1. A01HUU8E02
      Text in Illustration
      *a Lock Hole

      Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      33 N*m  { 340 kgf*cm, 25 ft.*lbf }

      Note

      Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

    2. Install the rear flexible hose with the bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

    3. Install a new clip.

      Note

      Install the clip as far as it will go.

    4. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench Click here.

  2. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

    Click here

  3. BLEED BRAKE LINE


    1. Bleed brake line.


      1. A01HTZV

        Remove the brake master cylinder reservoir filler cap assembly.

      2. Add brake fluid into the reservoir between the MAX and MIN level on the brake fluid reservoir.

        Brake fluid
        SAE J1703 or FMVSS No. 116 DOT3

      3. Connect the Techstream to the DLC3 and turn the power switch on (IG).

      4. Turn the Techstream on and enter the following menus: Chassis / ABS/VSC/TRAC / Air Bleeding.

      5. Select "Usual air bleeding" on the Techstream display, and bleed air from the brake fluid following the instructions on the Techstream.

      6. After air bleeding, tighten each bleeder plug.

        Torque:
        8.3 N*m  { 85 kgf*cm, 73 in.*lbf }

      7. Clear the DTCs Click here.

      8. Turn the Techstream off and turn the power switch off.

    2. Inspect for brake fluid leaks.

    3. Install the brake master cylinder reservoir filler cap.

  4. INSTALL REAR WHEEL

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }