FRONT SHOCK ABSORBER REMOVAL

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.


  1. REMOVE FRONT WHEEL

  2. LOOSEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    1. A01HTS6

      Loosen the front support to front shock absorber nut.

      Note


      • Do not remove the front support to front shock absorber nut.

      • Loosen the front support to front shock absorber nut only when the front shock absorber with coil spring needs to be disassembled.

  3. SEPARATE FRONT SPEED SENSOR


    1. A01HTHL

      Remove the bolt and clamp, and separate the front speed sensor and front flexible hose from the front shock absorber assembly.

      Note

      Be sure to separate the front speed sensor from the front shock absorber assembly completely.

  4. SEPARATE FRONT STABILIZER LINK ASSEMBLY


    1. A01HUB3

      Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.

      If the ball joint turns together with the nut, use a wrench to hold the stud bolt.

  5. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    1. A01HVXYE01
      Text in Illustration
      *1 Jack
      *2 Wooden Block
      A01HUVJ Front of the Vehicle

      Support the front axle using a jack and wooden block.

    2. A01HVZA

      Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.

      Note

      When removing the nuts, keep the bolts from rotating.

    3. A01HSER

      Remove the 3 nuts and front shock absorber with coil spring.

      Note

      Make sure that the front speed sensor is completely separated from the front shock absorber with coil spring.

  6. SECURE FRONT SHOCK ABSORBER WITH COIL SPRING


    1. A01HTZOE04

      Install SST to the front coil spring with the hooks spread as far apart as possible from each other.

      SST
      09727-30021   ( 09727-00010, 09727-00021, 09727-00031 )

      Note

      Make sure that the claws on the hooks are securely engaged to the spring.

    2. A01HSRXE03

      Install the bolt and nut to the front shock absorber assembly as shown in the illustration and secure the front shock absorber assembly in a vise using aluminum plates.

      Standard length A
      28 mm (1.10 in.)

  7. REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT


    1. A01HW9CE01

      Using SST, compress the front coil spring.

      SST
      09727-30021   ( 09727-00010, 09727-00021, 09727-00031 )

      Note

      Do not use an impact wrench. It will damage SST.

      If the front coil spring is compressed at an angle, using 2 SST will make the work easier.

    2. Check that the front coil spring is sufficiently compressed.

    3. A01HSUI

      Remove the front support to front shock absorber nut.

  8. REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY

  9. REMOVE FRONT SUSPENSION SUPPORT BEARING

  10. REMOVE FRONT UPPER COIL SPRING SEAT

  11. REMOVE FRONT UPPER COIL SPRING INSULATOR

  12. REMOVE FRONT COIL SPRING

  13. REMOVE FRONT SPRING BUMPER

  14. REMOVE FRONT LOWER COIL SPRING INSULATOR

  15. REMOVE FRONT SHOCK ABSORBER ASSEMBLY