TRANSMISSION CONTROL CABLE ADJUSTMENT


  1. INSPECT SHIFT LEVER POSITION


    1. While moving the shift lever from the N position to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.

    2. Put the vehicle into the READY-on state and check the following:


      1. When the shift lever is moved to the D position, the vehicle moves forward.

      2. When the shift lever is moved to the R position, the vehicle moves in reverse.

        Note

        The vehicle should not move when the shift position indicator is off.

  2. ADJUST SHIFT LEVER POSITION


    1. Move the shift lever to N.

    2. Remove the console box Click here.

    3. A01HVGG

      Disconnect the end of the transmission control cable assembly from the lower shift lever assembly.

    4. A01HSD5E03
      Text in Illustration
      *1 Slider
      *2 Lock Piece
      *a Slide
      *b Pull

      Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.

    5. A01HV60E01
      Text in Illustration
      *1 Lock Piece

      Install the end of the transmission control cable assembly to the lower shift lever assembly.

      Note


      • Check that the lock piece is pulled up.

      • Install the cable end all the way to the base of the pin.

    6. Push the lock piece into the adjuster case.

      Note


      • Check that the park/neutral position switch and the shift lever are in neutral.

      • Securely push in the lock piece until the slider lock is engaged.

    7. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.

    8. Install the console box Click here.